Here was a smart tip even if the thread is old and there is only a monologue.
I also got a tip about setting wheel in a lathe and turning it. I think I'll try sandpaper method first.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
General Tormek Questions / Re: Tormek SA-250
March 23, 2017, 08:38:58 AMHere was a smart tip even if the thread is old and there is only a monologue.
I also got a tip about setting wheel in a lathe and turning it. I think I'll try sandpaper method first.
Pages1