News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Scott K

Pages1
#1
General Tormek Questions / Re: cracked drive wheels
May 31, 2016, 09:49:30 AM
Ken 
I don't know if this is what you are looking for but manual lists the protruding distance of 40 to 50mm when using the Grinding Jig for gouges, SVS-40.
#2
General Tormek Questions / Re: cracked drive wheels
May 30, 2016, 08:34:36 AM
Hi all,

I've just been lurking in the background for a while.  I have a T7 and have just purchased a 2000 as a back up.  The 2000 came with an original manual (no dates) and lists the following:
EA-240 as a de-burring wheel. Aluminium Oxide.  "For tougher honing action". 

SK-85 Quick coupling kit for de-burring wheel on early SA-250 model.  Both honing wheels have a mounted steel plate for Quick Coupling.

ES-250 Grindstone.  Natural sandstone - For fast grinding.  Not suitable for HSS-steel.

Hope this helps. 
Regards Scott.
Pages1