Good morning. I have an old Supergrind 2000 which I have been very happy with. But over the last year, it seems to lose power after being used for a while, like 15-20 minutes. It does not take much power to stop the wheel from turning. Could there be a problem with the motor or a drive belt that needs replacing?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: Rusty Main Shaft
March 04, 2016, 08:59:05 PM
Thank you all. I will keep you updated on my progress.
Doug
Doug
#3
General Tormek Questions / Re: Rusty Main Shaft
March 03, 2016, 03:56:53 AM
Like many others here, I have a Supergrind 2000 that I have had for probably 20-25 years (pre-serial number) and I have the rusted shaft problem and want to replace it. Do I need to have anything other than the new MSK-250 stainless steel shaft? Any other nuts or bushings needed?
Pages1