News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Stenis49

Pages1
#1
General Tormek Questions / Re: About upgrading
February 25, 2016, 04:27:59 PM
Thanks!

This machine is old (About 1984) I am going to buy the tools that will help me make the wheel round again. It is a littlest oval now!
#2
General Tormek Questions / About upgrading
February 25, 2016, 12:58:24 PM
Hello!

I am completely new at the forum and have some questions
I bought yesterday a SA 250 and wonder how it is possible to upgrade this machine.
I will use it for woodworking tools and Woodturning tools.

There where no jigs following the machine and there is a 250 mm sandstone mounted!

Regards


Sten-Åke GRanberg
Pages1