Thank you both. John
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Windows 10 app location
November 11, 2023, 03:12:31 PM
Good day, I have Grinding_Angle_Setter on my windows 10 laptop somewhere. Does anyone know where it resides please? Thanks.
#3
General Tormek Questions / Re: How to measure existing angle on thin knifes with groves in angle master
November 03, 2016, 03:31:44 PM
Thanks for the reply Ken and Jan. I will just ignore the groves on the angle master for my knives. A note stating the groves in the angle master are not to be used for knives might be an idea Tormek could consider. Thanks again. John
#4
General Tormek Questions / How to measure existing angle on thin knifes with groves in angle master
November 02, 2016, 09:55:38 PM
Manual states that on thin knifes, where bevel small and is too hard to set angle master to, set angle master to blade and half the bevel angle you desire. So with his thin knife, how do you measure existing edge angle with angle master groves. With this type of thin knife, the groves are measuring the blade not the bevel, no?
Thanks
Thanks
Pages1