Did not get DVD. Maybe I should. THanks for the answer, and I really like this forum!! HIgh quality tool, and this forum makes it even better.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / General honing question.
January 10, 2004, 09:59:38 PM
Question oin hone wheel prep. There were no instruction that I remember, but I noted in the maintenance tool kit for sale there is some miner oil for the hone. Can I hear some amplification on this before I make a mistake and soak my hone in mineral oil.
#3
Planer Blade Sharpening / Re:Sharpening Planer Blades with your TORMEK
January 10, 2004, 08:28:10 PM
I've sharpened the two blades from my Dewalt 12" machine once. I think I did good. The other set is in the machine now (Pre Tormek - need two - one in use one to be sharpen - or sharp on stand-by). I Believe I was being a little heavy handed (I'm 6'2" at over 260# - lots of beef). As I leaned on the blade it caught the wheel and the whole thing recoiled and put a fair slice in two fingers (healed ok). So one piece of advice - go easy. I've only had my machine for a littel while and with the holiday rush I have done little shop upkeep. but one of these days I will do more. LOVE it thus far. 
Pages1