Messages

I did try it with the scissor slide, its is just not quite enough clearance for the jig, it still hit the wheel, I did learn an awful lot , I was very frustrated at first but just stuck with it. There is only 2-3 hours from start to finish , that's with all of the other failures.

It works perfect, many, many variations before I came up with this, I have to remake the slide with something other than wood, it slides nice but not perfectly round inside. I will insert a sleeve in the wood or remake it with plastic of some kind.

I just posted the images of the blade and the jig I fabricated, keep the feed back coming, appreciated

http://i1078.photobucket.com/albums/w497/sawknives/IMG_0001_zpsixdu6via.jpg

The feedback is great, thanks for the assistance, I will get photos posted this morning

Great information thanks, I will post pictures of the blades and jig I fabricated to see if any on can give me some further advise. I have been a sharpener for some time and wish I would have found this resource long ago.

I have, the angles dont work, the jig hits the wheel, not sure how to post a pic?

Has any one had luck with sharpening ice auger blades? I fabricated a jig to do Jiffy blades, seems to work quite well, any one else into this kind of sharpening, like to hear how you do them