Quote from: kb0rvo on September 02, 2015, 09:11:51 PMThe bar is 12mm and 92mm centres
That is interesting, Billy! What is the diameter of the support bar and the spacing of the two vertical legs of it (center to center)?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
General Tormek Questions / Re: Drill powered unit upgrades
September 06, 2015, 05:19:42 PM #2
General Tormek Questions / Re: Drill powered unit upgrades
September 02, 2015, 09:15:00 AM
got there in the end hope it was worth it 
#3
General Tormek Questions / Re: Drill powered unit upgrades
September 02, 2015, 09:13:17 AM
[/URL]][/img]
#4
General Tormek Questions / Re: Drill powered unit upgrades
September 02, 2015, 08:58:00 AM
[/URL]
[/img]
#5
General Tormek Questions / Re: Drill powered unit upgrades
September 01, 2015, 08:05:54 PM
Tried but failed to load images
#6
General Tormek Questions / Re: Drill powered unit upgrades
August 31, 2015, 05:01:10 PM
Hi kb0rvo
Yes it came with two vertical sleeves but was drill powered we have mounted it on a steel frame and added a motor and pulleys to reduce speed. Have photos but can't attach them?
Yes it came with two vertical sleeves but was drill powered we have mounted it on a steel frame and added a motor and pulleys to reduce speed. Have photos but can't attach them?
#7
General Tormek Questions / Re: Drill powered unit upgrades
August 31, 2015, 10:29:00 AM
]Thanks for your replies
I have just checked the machine and found that when purchased it came with two sleeves, it is a ST 250 model, (will post pictures when possible ) does this make a difference to the diameter of the support bar, was the single sleeve smaller than the two sleeve model
Billyb
I have just checked the machine and found that when purchased it came with two sleeves, it is a ST 250 model, (will post pictures when possible ) does this make a difference to the diameter of the support bar, was the single sleeve smaller than the two sleeve model
Billyb
#8
General Tormek Questions / Drill powered unit upgrades
August 28, 2015, 11:14:23 PM
hello
My father has the original drill powered unit but has put a motor on it. He would like to use the latest jig holders but we were told he needs to upgrade the support bar. Has anyone carried out this upgrade and do you still have the instructions
Thanks
My father has the original drill powered unit but has put a motor on it. He would like to use the latest jig holders but we were told he needs to upgrade the support bar. Has anyone carried out this upgrade and do you still have the instructions
Thanks
Pages1