I am getting good primary and secondary facets at on drill bits, but they won't drill mild steel.
Do I need a different angle on the tip.
Thanks for your help....!
Do I need a different angle on the tip.
Thanks for your help....!
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Block plane blades
June 28, 2017, 09:30:17 PM
I need to sharpen my Stanley block plane blade.
The blade is too thin to be clamped in the SE 76 jig.
Does any any one have any tips please?
The blade is too thin to be clamped in the SE 76 jig.
Does any any one have any tips please?
Pages1