Messages

I've been given a replacement head which is of the current standard, so all is well now.

Well done Tormek !

Robert.

Thanks !

I've been in contact with support@tormek in Sweden and they are going to sort it out for me.  That's a bit nearer me than the USA !!

Robert.

Thank you.
Is that telephone number in the USA ?  I live in Scotland - maybe I should email Tormek in Sweden ?

Regards,

Robert.

I've bought the upgrade kit to bring my SVD-180 up to the SVD-185 and have a problem with it.
The new knob screw for the tool holder is too big in diameter to fit in the existing brass fitting on the top of the tool holder.
Measuring bothscrews, the original thread is 5.75 mm and the new one is 7.76 mm.
There is nothing in the instructions with the kit to deal with this - I had expected them to be interchangeable.
How do I get round this one ?

Regards,
Robert.

Thank you.

I've been using the SVS-40 jig and have found it difficult to keep the correct angle on the whole surface of the gouge.   I'll try the 185 - it looks as though it will fix my problem.

Regards,
Robert.

Hello,
Can an SVD-185 gouge jig be used on an Supergrind 1200 ?   I can't see anything listed about their compatibility.
Thanks,
Robert.