News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Jordanaambargis

#1
General Tormek Questions / Re: i have a dirty stone
September 27, 2014, 05:03:41 AM
I was sharpening chisels and some were rusty. It seems like the metal is imbedded into the stone. Also the stone is dis colored. I will try your suggestions and will let you know tomorrow. Thanks
#2
General Tormek Questions / Measuring the stone
September 27, 2014, 02:30:16 AM
How do I measure the stone on my Tormek T3??  Thanks
#3
General Tormek Questions / i have a dirty stone
September 27, 2014, 02:24:17 AM
I recently started using my Tormek and the stone has gotten dirty.  Do I bring it back to life using the stone grader SP-650 stone or the Tormek Truing Tool?

Thanks