I did go to work on the round bit with a round file, but then I had second thoughts. What if the bit wobbled on the chisel because the hole was too big? BTW the SVD-005 new attachment is 12 something on line plus shipping--20 bucks and change. Seems worth it tho' considering one bit is $17.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Wood Turning / Re: Sharpening round bits on SVD-185
September 25, 2014, 01:47:53 AM
Thanks, Stig. I'll get right on it. (If there wasn't an upgrade, I would have suggested it.) Good company, Tormek!
#3
Wood Turning / Sharpening round bits on SVD-185
September 23, 2014, 09:16:02 PM
I have a set of Turnmaster chisels with replaceable bits. The SVD-185 has a accessory that sharpens these bits. My problem is that the screw that mounts the bit on the jig is too large for the hole in the bit. The people at Rockler where I bought both tools haven't a clue. Any suggestions?
Pages1