Messages

Thanks for that bit of information. I have been experiencing it, but had not yet stood back and analyzed what was happening. Makes good sense.

I also asked Nick about using the tormek. He said he uses the tormek when he does a show or demonstration because it is one machine which can sharpen all of his tools. However, he said he still uses a dry grinder for sharpening some of his tools at home. It was a quick "in passing" conversation. I'll ask what tools he uses which for the next chance I get.

He is a class act - good of him to address his target audience when training (not many beginnning turners will have a Tormek unless they've done a fair bit with Hand Tools).

Bill,

That is the same conclusion I came to - The tormek will not replicate the Ellsworth grind as provided on my Crown Ellsworth gouge.

Realistically, it probably is close enough for practical purposes, but will not grind all of the way back on the wings.

Ed,

I'm no authority, but I'm pretty sure that these speed controllers will only work on universal motors. these are the loud motors used by routers and circular saws. To my knowledge no grinders or belt sanders use universal motors.

Great!

Thanks!

Has anyone established a method for replicating the profile of the Ellsworth Signature Gouge on the Tormek?

TIA

I promise a considered answer tomorrow.  I am too tired tonight to dig into this can of worms.  I will link this thread to the Yahoo group after I decide just how to dump the worms out of the can.

Jeff,

I was excited to find this issue addressed on your site as I too know turners who bought tormeks but ended up not using them for their turning tools.
However, I cannot find your response. Do I need to find the Yahoo group?

Thanks,
Kurt