Thank you
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
General Tormek Questions / Re: How does LA-120 honing wheel attach/mount
June 20, 2014, 11:15:02 PM #2
General Tormek Questions / How does LA-120 honing wheel attach/mount
June 20, 2014, 05:32:38 PM
Hello, new guy in town. I acquired a Supergrind 2000 and need to purchase and mount the XB 100 horizontal base so I came here for information, which I found. Then I saw that there was a profiled honing wheel, used to be the LA100 but now seems to be LA-120 . . . . but can't find info on how it mounts.
Can I add it to the existing leather honing wheel (which is what I think I see in photos) to the outside of the big wheel, or do I have to remove the standard and only use one at a time? I searched "install LA 120" and "mount LA-120" and came away empty, but at least I tried.
Thank you, Patrick
Can I add it to the existing leather honing wheel (which is what I think I see in photos) to the outside of the big wheel, or do I have to remove the standard and only use one at a time? I searched "install LA 120" and "mount LA-120" and came away empty, but at least I tried.
Thank you, Patrick
Pages1