Messages

that's interesting. I've always made sure the knife sits as flat as possible in the jig and away from any tapering. i know what you are saying when talking about more than just lifting going on in the video. i found that to be a little confusing at first.
I've had another go at sharpening the knife. I checked if it was easier with rolling the jig over and lifting the knife handle yet this brings on way too much angle to the edge and is no good.
I've sharpened it like a standard knife and just lifted the handle. The angle changes as you get closer to the tip yet is sharper than what it was. I'm not 100% happy with it, even though i can slice paper. (not like a hot knife through butter though...) It's going to come down to practice i think.
I'm also taking the tormek to work on Wednesday and will put the dial indicator over the shaft. I've always believed there is a slight bend to it and want to rule it out.

No it doesn't. Why?

Hi everyone. This may have been covered already yet I haven't had any luck with the search function.
I'm getting the hang of sharpening knives now, yet I haven't had any luck with my skinning knife. It has a really strong radius toward the tip and it really feels awkward to me by lifting the knife handle. I feel as if the angle is changing and its not grinding correctly.
I've tried repositioning the knife in the jig to solely focus on the radius section yet this gives terrible results.
Could anyone suggest how i could sharpen this knife properly?