Hello Everyone,
I've just purchased a Tormek T-7 and have been reading the forums, watching videos and practicing with a relatively crappy set of Craftsmen (Sears) chisels. I follow the procedure set by Jeff Farris and others on Youtube and get a sharper edge, but nothing to write home about, that cuts paper, etc. I've done the course, then fine, then stropping bevel, then stropping the back. I know this is a general question, but I was wondering if anyone had any new person tips beyond what is in the forum.
THANKS!!!!
I've just purchased a Tormek T-7 and have been reading the forums, watching videos and practicing with a relatively crappy set of Craftsmen (Sears) chisels. I follow the procedure set by Jeff Farris and others on Youtube and get a sharper edge, but nothing to write home about, that cuts paper, etc. I've done the course, then fine, then stropping bevel, then stropping the back. I know this is a general question, but I was wondering if anyone had any new person tips beyond what is in the forum.
THANKS!!!!