Thank you for the advice. The pin tapped out. Now, lets hope I can get the motor to work.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / motor won't turn
January 04, 2014, 10:57:36 PM
I have a Tormek 2000 and the motor is frozen. There is no movement at all. I have tried to remove the motor from the machine but one of the mounting screws is located under the pivot shaft of the mounting hardware. Is there a trick to remove this? Thanks in advance for any help.
Pages1