Thanks for the quick reply, it isn't much trouble to slide the trough off and store it below the wheel. I was just expecting something in the instructions that I may have missed
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / New Owner - Water Trough
December 15, 2013, 05:23:30 PM
Have spent the day with my T-3 and wood turners Kit - very impressed and I am sure more practice will improve my set up time.
I used to polish stones on a wet grinder and was always told not to leave water in the trough, out of balance at start up could cause problems I think. Different stones and higher speed but there doesn`t seem to be any reference to it in the Tormek spec. Do I need to read it all again or have I missed something
I used to polish stones on a wet grinder and was always told not to leave water in the trough, out of balance at start up could cause problems I think. Different stones and higher speed but there doesn`t seem to be any reference to it in the Tormek spec. Do I need to read it all again or have I missed something
Pages1