Thanks Jeff!
Gary
Gary
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Truing of the Stone Grader
December 06, 2013, 09:37:15 PM
Hello all,
Just joined the forum group. Hello all! Here's my question- I've been using my T-7 for some time now sharpening just about everything I own that has an edge and I've noticed that I have created some pretty deep unevenness on the faces of my stone grader. I'm not sure if I am pressing too hard, not moving the grader enough, etc. but what is the best way to "true up" my grader? Thanks for your responses!
Gary
Just joined the forum group. Hello all! Here's my question- I've been using my T-7 for some time now sharpening just about everything I own that has an edge and I've noticed that I have created some pretty deep unevenness on the faces of my stone grader. I'm not sure if I am pressing too hard, not moving the grader enough, etc. but what is the best way to "true up" my grader? Thanks for your responses!
Gary
Pages1