Have not checked back here for a couple of days. I'll try to get a pic in the morning. It's a "chip" from the plastic housing covering a part of the motor.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: new owner - couple of questions
October 30, 2013, 07:18:18 PM
Thanks 65, kinda thought that might be the case...
#3
General Tormek Questions / new owner - couple of questions
October 30, 2013, 04:48:45 PM
Hi All,
Glad I found this site. My new T7 arrived yesterday and while unpacking it, a small chip of broken plastic fell out of the unit. Turns out, it's a small piece about the size of a quarter broken off of the plastic housing located right behind the grinding wheel. Nothing I think that will affect performance and not a big enough problem to return the unit I hope. If I were to ask for a new part sent from Tormek, I am not sure I would be able to get in there to replace it.
My main question is this: While looking for the broken area I noticed that the whole motor is slightly "loose" or has a small amount of back and forth movement when pressing with my hand. Is this normal for these units? Anything I need to worry about?
Regards,
David
Glad I found this site. My new T7 arrived yesterday and while unpacking it, a small chip of broken plastic fell out of the unit. Turns out, it's a small piece about the size of a quarter broken off of the plastic housing located right behind the grinding wheel. Nothing I think that will affect performance and not a big enough problem to return the unit I hope. If I were to ask for a new part sent from Tormek, I am not sure I would be able to get in there to replace it.
My main question is this: While looking for the broken area I noticed that the whole motor is slightly "loose" or has a small amount of back and forth movement when pressing with my hand. Is this normal for these units? Anything I need to worry about?
Regards,
David
Pages1