News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Jim S

Pages1
#1
General Tormek Questions / CPM 10V steel
November 01, 2013, 05:35:53 AM
Has any member had experience in sharpening CPM 10V wood turning tools?
If so, what grindstone worked best?
I have read several articles that are not consistent.
Any help would be appreciated.
Jim
Pages1