I just unpacked my T7, installed the stone, conditioned the honing wheel and after checking to see if the UTS was parallel with the stone I used the turing tool to get it straight. I then moved my UTS to the lower holes and noticed that it wasn't parallel to the stone. I can make it parallel if I pull one side of the support slightly out of the support hole and lock it but that does not seem right. Is there a way to adjust the lower or upper UTS support holes so that they are parallel to the stone? Or do I have a bad UTS?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
General Tormek Questions / Universal Tool Support Not Square to Stone
September 16, 2013, 12:32:28 PMPages1