News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - iggie zawicki

#1
General Tormek Questions / Distilled water
November 22, 2013, 05:26:59 PM
I recently purchased a Tormek sharpening system, used. The previous owner is adamant that distilled water be used in the trough. Is that a requirement, or is it not necessary?
#2
Thanks to all of you who responded. I appreciate that you took the time to offer a helping hand. Although I was skeptical of Jeff Farris' suggestion contained in the instructional he wrote several years ago, I found that by changing the tightness on the guide as illustrated in the PDF the angle disappeared in short order. I am now a happy camper. 
#3
General Tormek Questions / Chisel sharpening 101
August 20, 2013, 09:15:11 PM
I recently acquired a used Tormek sharpening system. The problem I am having is that the chisels are not sharpening to a square finish. I have checked all of the fixtures and everything is 90 degrees to the stone. I have the chisel placed in the guide at 90 degrees and move it steadily across the stone as the stone is turning. I have the same result if using either toward the stone sharpening or away from the stone. So I have both the upper guide and also the lower guide on this tool and get the same result at both locations. Can you suggest a remedy to this problem?
Also the tool does not have the scale on the face of the housing for measuring the size of the stone for angle setting, is that something I can pick up?
Thank you in advance for your help, I love the tool but for this one flaw.