Thanks Mike - tried contact cement and it seems to be repaired and functional. Have a few hand-plane blades to hone, and will let you know how it holds up.
Dave
Dave
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / 2000 Leather Wheel Repair
August 15, 2013, 07:11:35 PM
The honing wheel on my 2000 has just started to separate at the seam. The ends still align with no gap if I push the loosening end down. I'd like to simply re-glue this seam and was wondering what type of glue to use? I think this occurred because the machine was stored unused for a few years in a dry hot Southern California garage and the leather dried and shrunk a bit.
Pages1