The more I think about it, the more I think Mike is right...
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: Hock Marking Knives
April 13, 2013, 12:40:23 PM
Hi Herman - the marking knife I use is the one shown the third picture from the top of the link I put in the post. I thought of the SVM-00 but it doesn't look to me like I could pivot the knife enough to line the bevels up properly. I have had a miserable time trying to sharpen this thing and may have to go to another type of marking knife. The homemade jig might work but I am not sure I have the time to build it for this one use. .Thanks for the reply. Love the Tormek for everything else but this damn knife
#3
General Tormek Questions / Hock Marking Knives
April 13, 2013, 04:00:59 AM
Does anyone have a suggestion for sharpening a Hock Marking Knife on the Tormek (other than doing it freehand)? This is a steel blade, flat on one side with a spear point. There are pictures on the website.
http://www.hocktools.com/Knives.htm
This spear point does not seem amenable to the existing jigs, or have I missed something?
http://www.hocktools.com/Knives.htm
This spear point does not seem amenable to the existing jigs, or have I missed something?
Pages1