They are both the same.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Wood Turning / SVS-50 and Diamond Parting Tool
January 22, 2013, 08:08:42 PM
I purchased my Tormek 2000 and the complete set of jigs in 2006. I just purchased a lathe, and for the first time was sharpening turning tools on my Tormek. All went exceedingly well until I tried to sharpen my diamond parting tool using the SVS-50. Following the directions in the turning tool instruction guide, I mounted the parting tool. The threaded knob screw has a pointed end (which was great when I sharpened my roughing gouge), but trying to hold the edge of the parting tool would cause the tool to slip off whenever I tried to apply any kind of pressure. Surely I am missing something here, but there was no additional instructions and there was no alternative threaded knob. Any suggestions would be most welcome!
Pages1