Jeff, thanks a lot for the suggestion. I will give the ideas a try.
Sincerely,
Mike Narges
Sincerely,
Mike Narges
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Hand Tool Woodworking / #79 Side Rabbet plane, sharpening
December 05, 2007, 04:06:46 PM
Has anyone sharpened the skew beveled irons from this plane. Which is the suggested jig?
Pages1