News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - jeffmuscatine

Pages1
#1
Wood Turning / Re: SVD-185 - any suggestions for a tool holder for large gouges?
April 18, 2012, 07:53:15 PM
Seems the SVS-50 will work on the Work Sharp 3000 with the tool bar attachment.

Jeff
#2
Wood Turning / SVD-185 - any suggestions for a tool holder for large gouges?
April 18, 2012, 09:27:03 AM
Hello -

I have a large roughing gouge (Crown specs as 3/4") that does not fit into the tool holder of the SVD-185 jig.  Any suggestions?

Jeff
Pages1