Jeff,
Any chance you can make the "Sharpening Planer Blades" DVD a winter project?
CP Scholz
Any chance you can make the "Sharpening Planer Blades" DVD a winter project?
CP Scholz
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Planer Blade Sharpening / Re:Sharpening Planer Blades with your TORMEK
January 07, 2004, 06:29:33 AM #2
General Tormek Questions / Micro Bevels and Rounding Smoothing Plane Blades
January 07, 2004, 06:22:33 AM
I have two questions.
1) In the past I've used the Veritas sharpening jig and the scarey sharp system to put a 1 to 2 degree micro bevel on my bench chisels. Can the Tormek do this as well?
2) When sharpening my smoothing plane blade, I like to round the edges a bit to prevent tearout. Can the Tormek do this as well?
Thank you in advance for your reply.
CP Scholz
1) In the past I've used the Veritas sharpening jig and the scarey sharp system to put a 1 to 2 degree micro bevel on my bench chisels. Can the Tormek do this as well?
2) When sharpening my smoothing plane blade, I like to round the edges a bit to prevent tearout. Can the Tormek do this as well?
Thank you in advance for your reply.
CP Scholz
Pages1