Quote from: Ken S on February 20, 2012, 01:06:33 AM
The EZY Lock shaft made wheel removal a snap.
Ouch! Interesting choice of words there Ken...
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
General Tormek Questions / Re: Moving with a Tormek
February 20, 2012, 02:28:43 PMOuch! Interesting choice of words there Ken...
#2
General Tormek Questions / Re: Out of square edge
February 17, 2012, 07:46:11 PM
Remember that the correct honing angle is achieved by a combination of two adjustments - the distance of the tool rest from the wheel and the distance of the blade edge from the clamping part of the jig. It sounds to me as though you need to pull the tool rest out further and compensate by adjusting the blade in the jig (or it may be the other way round, depending on where the clash is happening).
David
David
Pages1