I just bought the holder for my dry 6" grinder about 10$ in your money and used the 'bent piece of stainless with a nut' from the Tormek! I always do any major reshaping on the 6" grinder then move to the Tormek system, yes I agree it does take a while to get used to. Stick with it I'm only about 6 weeks into mine. I watch the video that can with the turners kit to give some major help.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Wood Turning / Robert Sorby Hardwood Scraper
March 01, 2012, 10:09:51 PM
Hi
This is my very first post! I must say I found the post on sharpening a skew chisel very good - I have been pulling my hair out as I thought I'd never get it re-ground - Thanks
Now I have a Robert Sorby hardwood scraper, this has a slight radius and two different angles. My question is how the hell do I sharpen this scraper? HAs anyone else done this, any help would be greatly received.
Thanks
Brian
This is my very first post! I must say I found the post on sharpening a skew chisel very good - I have been pulling my hair out as I thought I'd never get it re-ground - Thanks
Now I have a Robert Sorby hardwood scraper, this has a slight radius and two different angles. My question is how the hell do I sharpen this scraper? HAs anyone else done this, any help would be greatly received.
Thanks
Brian
Pages1