Well, now that you mention it, that must clearly be my problem. I must have misread the instructions or misinterpreted a picture or something. Thanks.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re:Sharpening a wide hand plane iron
January 12, 2006, 02:49:16 AM
It did not work for me. I am trying to fit a Lie-Nielson #7 iron on there and when I straddle it around the one screw post of the SVH-60, the jig will not slide far enough to the left to grind the last 3/8" of iron hanging off the wheel on the right.
#3
General Tormek Questions / "mineral oil" for honing wheel
January 12, 2006, 02:43:03 AM
I am wonderng if I need to go out and purchase something called "mineral oil" or whether I can use any petroleum based oil to intially charge my honing wheel. Any thoughts? Does it really matter? Can I just use "3 in 1" oil?
Pages1