I recently acquired a Tormek that has been used hard. The first problem I have is that when I tighten the grinding stone on, the inner edge of the honing wheel scrapes the left side of the housing. There is a washer on the shaft, and the bushings are new. The previous owner had this problem, the paint is scraped off where the honing wheel and the housing meet, and oxidation has begun. Is this a problem I can fix with two washers? Or is the honing wheel and/or the drive wheel tightened too far down the shaft?
Also, the knob on the honing wheel seems to spin with some resistance, but is not loosening or tightening anything. What is the problem with this? I can't remove the honing wheel with this.
The grinding wheel has a deep rut, but lots of diameter left. The leather honing wheel is dessicated, but whole and fairly thick. What parts should be replaced?
Also, the knob on the honing wheel seems to spin with some resistance, but is not loosening or tightening anything. What is the problem with this? I can't remove the honing wheel with this.
The grinding wheel has a deep rut, but lots of diameter left. The leather honing wheel is dessicated, but whole and fairly thick. What parts should be replaced?