please could any one tell me how to sharpen a continental spindle gouge, and what jig to use many thanks
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: SVD-110 Toolrest
May 30, 2012, 08:32:31 AM
will give that a try many thanks ray
#3
General Tormek Questions / Re: SVD-110 Toolrest
May 28, 2012, 09:06:16 AM
my skew chisel is to large to fit svs-50 jig
#4
General Tormek Questions / SVD-110 Toolrest
May 22, 2012, 06:31:32 PM
has anyone made a SVD-110 Toolrest so that a mitre gauge can be use as i have larger skew chisels, and can not hold them at the right angle and move across stone help needed
#5
General Tormek Questions / jig spares
July 01, 2011, 06:33:53 PM
can anyone please tell me where in the uk ,can you buy parts for svs-50 jig and svd jig ,all help would be appreciated many thanks
Pages1