Help!!
I just purchased a set (2) of Alan Lacer signature woodturning skew
chisels. These skews are very nicely made of substantial steel (3/8"
thick 2030 steel).
Last night I did the initial sharpening on the smaller of the two (5/8"
wide). My old Tormek 2000 & multi-jig did a great job (the skews have
a radiused edge) - though it took awhile (2030 steel is *hard*).
When I moved to the larger (1 3/8" wide) skew, I discovered that it
will not fit into my multi-jig - it's too big!
Anybody have any ideas how I can use my Tormek system to sharpen this
bad boy??
thanks! - Gerry Kmack
I just purchased a set (2) of Alan Lacer signature woodturning skew
chisels. These skews are very nicely made of substantial steel (3/8"
thick 2030 steel).
Last night I did the initial sharpening on the smaller of the two (5/8"
wide). My old Tormek 2000 & multi-jig did a great job (the skews have
a radiused edge) - though it took awhile (2030 steel is *hard*).
When I moved to the larger (1 3/8" wide) skew, I discovered that it
will not fit into my multi-jig - it's too big!
Anybody have any ideas how I can use my Tormek system to sharpen this
bad boy??
thanks! - Gerry Kmack