News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - briandavies

Pages1
#1
General Tormek Questions / turning cutters
February 14, 2007, 08:39:14 PM
Hi
I use my tormek for sharpening woodturning and wood working tools
and was wondering could i use the tormek to take a very slight chip out of a metel turning cutter
thanks
Pages1