Something to remember is that even though it may take a long time to get a chisel back into shape, once done, the resharpening and touch up of the same chisel will go very quickly the next time. All the major work would already be done.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: Changing Stones
December 05, 2011, 06:20:39 AM
I wouldn't think you'd have to true it up again. I removed my stone after truing it and I'm sure I didn't put it back in the exact same position and it was fine when I checked for that very thing.
#3
General Tormek Questions / Re: WM-200 Angle Master Accuracy
April 27, 2011, 09:43:21 AMQuote from: GIPPER on April 25, 2011, 11:57:12 PM
How accurate is the angle measurements for this device? If I place it horizontally on a flat surface, I get 17.5 degrees. How does this compare with others?
I've found it to be very accurate. I sharpened a set of 5 chisels last week and the WM-200 settings were right on. The angle was 30 degrees and each chisel was sharp. Are you sure you had the settings correct on the 200? It should have been spot on.
#4
General Tormek Questions / Re: SVD-185 Gouge Jig
April 22, 2011, 01:30:00 AM
I've never read that the SVD-185 jig should be placed in the vertical position. Only horizontally.
Pages1