News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - terrylund

#1
Wood Turning / Sharpening an "Alan Lacer" skew
March 20, 2011, 02:21:12 AM
I'm a brand new member to the forums but tried to read over the relevant articles regarding skews.  What is the best way to sharpen a large skew with the "Lacer profile" which is straight for ~1/3 of the width and curved for the remainder, and the overall angle on the end is ~70 degrees.  The skew is 3/8" thick and 1-3/8" wide so it doesn't fit into the regular skew jig at all, and that would only work (as I understand it) for a straight edge.