News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - sharpeningshack

#1
Hi Ken,

Yes I do sharpen with other diamond stone sharpeners but they tend to remove to much metal because of the hi-speed of the diamond wheels. That's why I want to move to the Tormek. I think it will do a better job and remove a lot less metal...Thanks for the recommendation, I have been doing the local Cable Guys bits for about a year now.

Regards Matt
#2
Thanks Ken for the input, that's what I needed to know about bowling ball bits.......... I think I will still order the jig for my other drill bits.... Any recommendation on Carbon Tipped drill bits as far as the stone to use?

Thx Matt ;D
#3
Hello Tormek Board,

Question for someone, I have some customers that want to know if the new drill bit attachment can sharpen Bowling Ball Drill bits that have a small 1/2 shank with the main drill bit up to 1 1/8" Carbide tip. I was going to buy the new drill bit adapter and a SB-250 - Blackstone Silicon stone....

I would appreciate any comments as to the drill attachment working on large diameter bits and the Silicon stone...

Thx Matt in San Diego