I recently gave my trueing tool another go, being very careful not to cut too deep and it worked fine. Thanks so much for the support and good advice. 
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: Problem with trueing tool
May 19, 2011, 06:21:49 AM
Thanks heaps for the tips. I'll give it a go.
#3
General Tormek Questions / Problem with trueing tool
May 16, 2011, 07:35:09 AM
Hi, I have recently purchased the Tormek trueing tool to grind flat the grindstone on my Tormek 4000. I carefully followed the instructions in the handbook and found that the when I began trueing the stone there was considerable vibratation which caused gauges in my stone. I've read previous posts which suggest to increase the truing speed, but this did not help. I also tried trueing from left to right and right to left and still experienced the same problem. Any other suggestions??
#4
General Tormek Questions / Sharpening mincer blades
March 23, 2011, 10:30:25 AM
Hi,
Just wondering if it is possible to sharpen mincer blades on the Tormek Supergind 4000? If so how do I go about it? Can anyone help with my sharpening question??
Just wondering if it is possible to sharpen mincer blades on the Tormek Supergind 4000? If so how do I go about it? Can anyone help with my sharpening question??
#5
General Tormek Questions / re-profiling knife
November 25, 2010, 03:55:11 AM
What is meant by the term re-profiling?
Pages1