News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - malced

#1
General Tormek Questions / Metal lathe tools
November 25, 2010, 09:42:12 PM
I saw a thread on here recently about sharpening HSS metal lathe tools.

I recently made a couple of jigs to fit my Tormek 2000 for sharpening these tools. I have found that the fine finish I can get, particularly on thread cutting tools makes a significant difference to the quality of the finish I can achieve on my lathe.

I have tried to upload some images of them but being a computor 'dummy' I have been unsuccessful. If someone could give me an 'idiots guide' on how to do this I would be grateful!