Someone has asked if I can sharpen a Japanese cermic knife? Any tips? Can I?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re:TT-50 Directions
December 18, 2006, 03:41:36 PM
Okay, I'm a dummy. I did find the english directions finally. But still have a question. When I saw Jeff at the show, with the old truing tool he talked about truing from the outside of the stone to the center, to prevent chipping. You could lift slightly on the univeral support end and then work back in from the edge. Shouldn't you still do this? It may take longer but safer for the stone.
#3
General Tormek Questions / Re:TT-50 Directions
December 18, 2006, 05:04:50 AM
If I could read french, swedish, or the other languages I could. The box doesn't have that good of details. Thought they might be posted on one of the web sites.
I think I figured it out. But wanted a better refernce, to refer to.
I think I figured it out. But wanted a better refernce, to refer to.
#4
Wood Turning / Re:Ellsworth grind
December 17, 2006, 11:03:52 PM
What is the distance to the stone. I'm not copying, or regrindinganother chisel?
#5
General Tormek Questions / TT-50 Directions
December 17, 2006, 10:45:25 PM
Where and when can we get the directions for the new stone truing tool? I'm a newbie.Pages1