Thank you
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Tormek 2000 supergrind grindstone removal
April 29, 2014, 11:00:55 PM
I have a Tormek 2000. I decided to purchase a new silicon grinding wheel and the new easy-lock stainless shaft system upgrade. The new parts installed easily but I cannot remove the old shaft from the AO grinding wheel. It appears that it has rusted onto the shaft and bushings. Has anyone encountered this problem? I do not want to lose the old grinding stone as it is only worn by 1/2 inch.
Please help.
Lou Robbio
Please help.
Lou Robbio
#3
General Tormek Questions / BGM-100
April 12, 2014, 01:02:12 AM
I have an older version of the BGM-100 (without the metal mounting block). Can I purchase the metal mounting block separately or do I have to buy a whole new unit? If I can purchase where would I do so?
Lou
Lou
Pages1