News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Guapo

Pages1
#1
General Tormek Questions / Re: A Bit of Wobble
September 23, 2010, 03:54:43 PM
Great info.  Once I receive the bearings and begin the work, I'll definitely look at that.  Thanks for the help and advice.
#2
General Tormek Questions / Re: A Bit of Wobble
September 22, 2010, 02:42:13 PM
That's great info.  I truly appreciate it. 

Is this the part: "Nylon bearing"?  I found it here:  http://www.sharptoolsusa.com/index.php?target=part&partsProdID=193&catID=6
#3
General Tormek Questions / Re: A Bit of Wobble
September 22, 2010, 01:44:04 AM
Is this something I can do myself and where do I get these bearings?
#4
General Tormek Questions / A Bit of Wobble
September 21, 2010, 08:17:58 PM
I have an older 2000.  I got it out and went to true the wheel over the weekend and I noticed the grind wheel, the honing wheel, and the profiled wheel all wobble.  I haven't used it for a few years (4 kids...no time to work with wood), and I don't remember it doing this before I put it away for hibernation.  I'm assuming this is something I should be concerned about.  Any thoughts?  Would a new shaft fix this?

Thanks,

David
Pages1