I have found that using a foot operated switch enables me to easily use both hands and have the back of the blade in flat contact with the side of the wheel before it starts turning. It stays in contact until after the wheel stops. This has eliminated the risk of rounding over an edge.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
General Tormek Questions / Re: flattening chisel and plane backs, Ron Hock suggestion
August 03, 2010, 10:01:27 PMPages1