Hi Herman
Thanks for your info--and an interesting thread: 'Rusty Main Shaft'
Mike
Thanks for your info--and an interesting thread: 'Rusty Main Shaft'
Mike
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / T-3 v. Bench Stones
May 26, 2010, 05:34:41 PM
I am thinking of buying my first Tormek grindstone, the T-3 model. Up untill now I have used up to 4000 grit Japanese Bench Waterstones, moderate sucesss, not brillient.
Questions: a) By using the T-3 would that be an improvement on the bench stones?
b) Would I get better results, after using the T-3, to finish off using the finer grit Japanese waterstones?
c) Is it a good idea to buy a second hand Tormek machine?--'wear & tear', especially with the grindstone? ('Penny wise--pound foolish'.)
Your expertise grately appreciated.
Thank You.
Questions: a) By using the T-3 would that be an improvement on the bench stones?
b) Would I get better results, after using the T-3, to finish off using the finer grit Japanese waterstones?
c) Is it a good idea to buy a second hand Tormek machine?--'wear & tear', especially with the grindstone? ('Penny wise--pound foolish'.)
Your expertise grately appreciated.
Thank You.
Pages1