News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Herb

#1
General Tormek Questions / Re: Wheel stopping
April 18, 2010, 08:40:31 PM
Thanks, Jeff!

Herb
#2
General Tormek Questions / Wheel stopping
April 18, 2010, 04:23:01 AM
Lately when I change from one grit to the other my wheel will come to a stop.  The shaft that turns the rubber wheel is still turning but the wheels are not.  I have noticed that when pressure is applied to the grinding wheel the motor shaft moves downward and toward the back.

I have the Supergrind 2000 and though it is many years old it has less than three hours honing on it--I tend to buy and use later.

Any suggestions?  I have tried sanding the rubber wheel with very little improvement and the sharpener has been covered during its none use.

Thank you,

Herb ???