News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - retseih

Pages1
#1
General Tormek Questions / Re: Problem with wheel stalling on Supergrind 2000
April 11, 2010, 05:19:36 PM
thx Jeff I will give this a try...Dick
#2
General Tormek Questions / Problem with wheel stalling on Supergrind 2000
April 10, 2010, 08:46:03 PM
I have a Tormek Supergrind 2000 and it will work fine on about 5 chisels.  After that when I "lean" into it to take out a nick in the chisel the wheel will slow then stop as the motor stalls.  The machine has only had light use over the several years I have owned it.  I have had the honing wheel off, but there is nothing obvious.  Anything I can try?

thx, Dick
Pages1