News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Joe

Pages1
#1
General Tormek Questions / Re: Problem with knife sharpening
May 22, 2011, 08:47:13 PM
I think my stone may be glazed over as well.  Which corner of the grader should I use to try and deglaze, the coarse or fine?  Thanks.
#2
General Tormek Questions / When to order new stone
August 01, 2010, 10:58:27 PM
How far down do you let your stone wear before you order a new one? At what size can you no longer use the stone? I sharpen 100-150 knives per week.  Thanks.
#3
General Tormek Questions / Re: Advice on Truing the T7
July 14, 2010, 03:42:09 PM
Thank you very much.  Watching the video really helped. My stone was very uneven.  I adjusted only the minimum amount each time and made several passes and now the stone looks great. 
#4
General Tormek Questions / Advice on Truing the T7
July 14, 2010, 04:45:43 AM
I need to tru the stone on my T7.  I read the instructions, but I am a little uncertain of how to do it.  Any advice or tips for a first-timer?
#5
General Tormek Questions / Newbie Having Problems Getting an Edge
April 10, 2010, 08:33:03 PM
I have had the Tormek T7 for about a week and have had a lot of success getting an edge on several different types of knives.  Today, however, I could not seem to get an edge at all.  I don't think I'm doing anything differently.  Are there any adjustment tips that might be helpful?  Any troubleshooting advice?

Thanks for your help. Joe
Pages1