It worked and thanks.
Now I have to find a new motor.
Now I have to find a new motor.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Motor
May 14, 2010, 02:32:53 AM
Having removed all visible screws that hold the motor to the housing, the motor will not come out of the housing.
I am just short of giving the shaft a good wack to see if it may pop out.
Any solutions / ideas?
I am just short of giving the shaft a good wack to see if it may pop out.
Any solutions / ideas?
Pages1